DIY pc to ps3 usb controller


Moved: link.

» Outdated content «

12 Replies to “DIY pc to ps3 usb controller”

  1. Can you use the software as it is with PC built-in RS-232 port, instead of the converter?

    If not, can this feature be added?

    Thanks.

  2. Unfortunately, the rs232 port on a PC does not operate at the same voltage levels than the TTL levels. In the end you still will need a converter. I think it's better to directly buy a usb to serial TTL converter.

  3. Oooh, very tempted to try this, but I think I need to use jumper wires instead of soldering this stuff. Does this look like a good kit?:

    http://cgi.ebay.com/Serial-Converter-USB-2-0-TTL-UART-6PIN-Module-CP2102-/120726707813

    http://www.dealextreme.com/p/breadboard-jumper-wires-for-electronic-diy-70-cable-pack-80208?r=99788910

    http://www.dealextreme.com/p/30cm-breadboard-wires-for-electronic-diy-40-cable-pack-80207?r=99788910

    http://www.dealextreme.com/p/designer-s-teensy-usb-development-board-for-ps3-47609?r=99788910

    The Teensy seems to be a fake one but apparently it has the right chip (at90usb162)

    I'll definitely make a video of me putting it all together and using it if it works 😀

  4. Look at the schematic: one side plugs into the pc (usb to serial converter = type A usb), and the other side to the ps3 (teensy = mini-A usb).

Leave a Reply to matlo Cancel reply

Your email address will not be published. Required fields are marked *